The Led Indicators; The Installation Procedure - Linksys Instant Wireless Series User Manual

Chapter 3: Getting to Know
the Dual-Band Wireless A+G
PCI Adapter

The LED Indicators

The Adapter's LEDs display information about network activity.
ACT Green. The ACT LED lights up when the Adapter has an active connection. It flashes when
data is transmitted or received.
Chapter 4: Software
Installation and Configuration
The Dual-Band Wireless A+G PCI Adapter Setup Wizard will guide you through the installation
procedure. The Setup Wizard will install the driver and WLAN Monitor, as well as configure the
Adapter.
Insert the Setup Wizard CD-ROM into your CD-ROM drive. The Setup Wizard should run
automatically, and the Welcome screen should appear. If it does not, click the Start button and
choose Run. In the field that appears, enter D:\setup.exe (if "D" is the letter of your CD-ROM
drive).
On the Welcome screen, you have the following choices:
Install - Click the Install button to begin the software installation process.
User Guide - Click the User Guide button to open the PDF file of this User Guide.
Exit - Click the Exit button to exit the Setup Wizard.

The Installation Procedure

1. To install the Adapter, click the Install button on the Welcome screen.
2. After reading the License Agreement, click the Next button if you agree, or click the Cancel
button to end the installation.
3. The Setup Wizard will ask you to choose a network mode. Click the 5GHz + 2.4GHz radio
button if you will connect to both 802.11a and 802.11g networks. Click the 5GHz radio button if
you will connect only to 802.11a networks. Click the 2.4GHz radio button if you will connect only to
802.11g or 802.11b networks.