Self-Diagnosis; Temp Sensor & Heater Check - Samsung NV51K7770 Series Installation Manual

Self-diagnosis

Self-diagnosis
Temp sensor & Heater check
1. After connecting the power, check if the display works properly.
2. Remove all accessories (Gliding Rack, Flat-Rack, Smart Divider...etc.) from
inside of the oven cavity.
You cannot proceed with self-diagnosis if the oven cavity is hot or the door is
3.
open.
• In this case, "Hot or door" message appears on the display.
4. To start self-diagnosis, press both Hidden Keys simultaneously for 5 seconds.
• Refer to the table below for the hidden keys for each model.
Model NV51K6650**
Control panel
Keep Warm + "9"
Hidden Key
Model NV51R5511**
Control panel
Hidden Key Keep Warm + "9"
16 English
Install_NW9000K_DG68-00862A-08_EN.indd 16
5. If there is no error, 'PASS' appears on the display with an alert sound.
6. If there is an error, following message appears on the display with an alert
sound.
Feature
NV51K7770**
7. If an error occurs, contact a Samsung service center for further service.
NOTE
If you see any other error messages that are not listed above, please contact a
Samsung service center. call e.g. 1-800-SAMSUNG (726-7864)
UPPER + LOWER
and touch "Install test" on
display.
Model
Error code
Upper Broil H-2
Upper Bake H-1
Lower Broil H-4
Lower Bake H-3
All models
Remark
Double/Single Oven
Double Oven Only
2019-05-09 12:06:21