Radio; Mp3 Player - Philips HTD3540 User Manual

4
Press to stop slideshow.
5
Press again to stop music.

Radio

Listen to FM radio on your home theater, and
store up to 40 radio stations.
Note
•
AM and digital radio are not supported.
•
If no stereo signal is detected, you are prompted to
install the radio stations again.
1
Connect the FM antenna to the FM
ANTENNA on your home theater.
• For the best reception, place the
antenna away from your TV or other
sources of radiation.
2
Press RADIO to switch to radio source.
» If you have already installed the radio
stations, the last channel that you
listened to is played.
» If you have not installed any radio
stations, the message AUTO
INSTALL...PRESS PLAY appears on
the display panel. Press
install radio stations.
3
Use the remote control to listen or to
change radio stations.
Play buttons
Button Action
/ Select a preset radio station.
or
Alphanumeric
buttons
Navigation
Left/Right: Search for a radio
buttons
station.
Up/Down: Fine tune a radio
frequency.
(Play) to
Button Action
Press to stop the installation
of radio stations.
Press and hold to erase the
preset radio station.
RADIO Manual:
1) In radio mode, press
2) When a radio frequency
3) Repeat step 1 and 2 to
Automatic:
In radio mode, press and
hold RADIO for three
seconds to reinstall all the
available radio station.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz.
1
Press RADIO to switch to radio source.
2
Press .
3
Press and hold
50 kHz or 100 kHz.

MP3 player

Connect a MP3 player to play audio files.
What you need
• An MP3 player.
• A 3.5mm stereo audio cable.
1
Using the 3.5mm stereo audio cable,
connect the MP3 player to the AUDIO IN
connector on your home theater.
• If you use 6.5mm stereo audio cable,
connect the MP3 player to your
home theater using a 3.5mm - 6.5mm
converter jack.
RADIO.
blinks, press OK to store
the radio station.
store other stations.
(Play) to toggle between
EN
15