B2. Installing The Charcoal Filter - Samsung MC17F808KDT Installation Instructions Manual

3. Remove the screw that holds the blower motor
and carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit.
CAUTION: To avoid breaking or cracking the blower
blade, do not touch the blade. Hold the outer case
of the blower when you pull it out or put it back in
place.
4. Roll the blower unit 90 ° so that the fan blade
openings are facing toward the front of the
microwave.
Before Roll
Back of
Microwave
After Roll
Manual-Installation_MC17J8100CS_AC_DE68-04129B-02_EN+CFR.indb 13
Step-by-step installation guide
blower mortor screw
Back of
Microwave
5. Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
6. Secure the blower unit to the microwave with the
screw.
B2. INSTALLING THE CHARCOAL
FILTER
1. Remove the screws on the top of the grill using a
#1 Phillips screwdriver.
2. Open the door.
3. Remove the grill.
• Push the grill left, and then pull the grill straight
off.
4. Install the charocal filter. When properly installed,
the wire mesh of the filter should be visible from
the front.
5. Reinstall the grill and the screws.
6. Close the door.
Insert mesh-side up
13
Charcoal filter
2017-11-02 2:47:03