Hitachi HDB60 Instruction Manual page 19

When the Timer screen is displayed, any event can
be set to be Inactive (so it will not occur) or the
channel, times and frequency mode altered by
highlighting the event's Mode button and pressing
[SELECT] as before.
You can exit the Timer screen and return to normal
TV viewing by pressing [MENU].
Hint
If you are watching digital terrestrial TV at the
time the timer event starts, a message is flashed
onto the screen announcing that the receiver is
'Switching to timer channel' so you understand
what is happening.
RE-INSTALLATION
Although your HDB60 receiver will not lose its
settings or stored channels when switched off, you
may wish to re-install the receiver because you
have moved to a different area with different
broadcast frequencies, you wish to reinstate a
channel previously deleted from the channel list, or
you want to watch new channels which have started
broadcasting.
Press the [MENU] key to display the Main Menu
and using the [UP] or [DOWN] keys, highlight the
Installation line and press [SELECT] to display the
Installation Menu.
You can either perform a First Time Installation,
effectively resetting the receiver to its ex-factory
condition, or just search for channels.
FIRST TIME INSTALLATION
To reset the receiver, highlight the First Time
Installation line in the menu and press [SELECT]. A
warning screen is displayed in case of accidental
operation.
Highlight the YES button with the [LEFT] or [RIGHT]
key and press [SELECT] to erase all the channels
and settings and switch the receiver to standby.
You can now start again as detailed in Section 1 -
PREPARATION - Tuning In.
All manuals and user guides at all-guides.com
- 18 -
ADD CHANNELS
The HDB60 receiver can search for channels
automatically (searching all the broadcast
frequencies for free-to-air channels) or manually
(searching one specified broadcast frequency only
for any channels to be found there).
Press the [MENU] key to display the Main Menu
and using the [UP] or [DOWN] keys, highlight the
Installation line and press [SELECT] to display the
Installation Menu. Highlight the Add New Channels
line and press [RIGHT] to display the options. Select
Automatic Search with the [UP] or [DOWN] keys
and press [SELECT]. A warning message is
displayed. This starts the automatic tuning process
as described in Section 1 - PREPARATION - Tuning
In, and searchesthrough all the available broadcast
frequencies for free-to-air channels. Previous
channels will be replaced on automatic search.
If, alternatively, from the search options menu the
Manual Search line is highlighted and [SELECT]
pressed, the manual search screen is displayed.
Highlight the YES button with the [LEFT] or [RIGHT]
key and press [SELECT] to start the automatic
search.
This is for searching for digital channels on a single
broadcast frequency. The frequency channel
number (21-69) is entered in the box at the top left
of the screen and the received signal level and signal
quality can be observed on the bar graph and signal
quality indicator at the bottom.
When [SELECT] is pressed, the receiver searches
that frequency and display a list of the channels
found. Before returning to the Installation menu.
Again, channels which duplicate those already in the
channel list are ignored. However, the manual
channel search will find all channels on the broadcast
frequency.
When either search is finished, press the [MENU]
key to return to normal broadcast viewing, to watch
the new digital terrestrial television channels found.