Install System Devices; System Smartcard; System Box; Set Communication Source - Philips 32HFL5850D/10 Setup Manual

9

Install system devices

Caution
C
Before installing a System SmartCard or
System Box, disconnect TV from mains.
9�1

System Smartcard

Note
D
Not applicable for 22 inch models.
1. Insert the SmartCard into the SmartCard
slot on the back of the TV.
2. Connect the cables as instructed by the
system provider.
3. Switch on the TV.
9�2

System Box

1. Insert the RJ12 cable of the System box to
the DATA 1 connector on the back of the
TV.
to DATA 1
System Box
2. Connect the cables as instructed by the
system provider.
3. Switch on the TV.
9�3 Set communication source
The default setting for COMMUNICATION
in the SETUP menu is OFF. If a SystemCard
or System Box is used with this TV, then you
must set to the correct communication link.
1. Enter SETUP menu.
2. Press ï to select COMMUNICATION.
3. Press Æ to enter COMMUNICATION.
4. Press Æ to select the correct link.
COMMUNICATION
COMMUNICATION
STORE
ENABLE CARD SLOT
DCM TYPE
5. Press ï to select ENABLE CARD
SLOT.
6. Press Æ to select YES.
7. Press Î to select STORE.
8. Press Æ to confirm.
SP - 12C
>
YES
GENERIC
EN-25