Basic Operation
Basic operation
1 Connect the supplied switching adapter to
the wall outlet and the DC jack on the set
or insert batteries as described in
Supply
.
➜ The clock information is displayed. (See
Press 2 to switch on the set.
•
Press 2 again to switch to standby mode.
•
2 To adjust volume, turn VOLUME +/–.
Helpful hints:
–
When there is no power supply for the set,
time information can still be displayed for a
few minutes.
–
After a few minutes,
and then time information is cleared.
Resetting to the factory setting
1 Press and hold DBB/SET TIME and
TIMER at the same time when connecting
the set to AC power supply or inserting bat-
teries.
➜ The software version is displayed.
➜ The set enters testing mode.
2 To reset, press POWER.
➜ All icons are displayed on the LCD dis-
play.
.
➜ The set is reset.
Power
2)
appears and flashes
Switching on radio
1 Press 2 to switch on the set.
2 Press SOURCE to select FM or MW wave-
band.
➜ Waveband and radio frequency are dis-
played
(see 3 and
Auto tuning
1 In FM/MW mode, press and hold MEMO-
RY/AUTO SCAN until
➜ The set scans stations with strong signal
strength and stores them as preset sta-
tions automatically.
2 Press TUNING +/- and hold it for one sec-
ond; the set searches a station automatically.
➜ Sr ch appears.
➜ When a station is received, search stops
and Sr ch disappears.
Helpful hints:
–
You can press any button except power to
exit auto search.
Manual tuning
By using this feature, it is possible to manually
tune to a specific channel frequency. In addi-
tion to antenna orienting for better radio
reception, the optimum reception can also be
obtained by using this feature.
1 In FM/MW mode, press TUNING +/- to
tune to stations.
2 Press and hold TUNING +/- to adjust fre-
quency fast.
Radio
4).
appears.
SCAN