Toro 117-4092 Manual

Electrical Service Kit
2008 and Before Emotion 43 Model 21027 Lawn Mower
Model No. 117-4092
Use these instructions to install and replace the fuse on
your mower in addition to the information found in
the Operator's Manual. Keep this addendum with your
Operator's Manual for future reference.
Installing the Fuse
No Parts Required
Procedure
Your mower comes with a 40-amp fuse that protects the
electric starter.
Important: You cannot start the mower with the
electric starter or charge the battery unless you
install the fuse.
1. Open the battery cover (Figure 1).
Figure 1
1. Battery cover
2. Fuse holder
2. Locate the fuse holder from the upper left corner of
the opening to the battery compartment (Figure 1).
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
3. Fuse (shown installed)
Register at www.Toro.com.
Note: The wire to the fuse holder is short; you will
not be able to pull the fuse holder fully out of the
battery compartment.
3. Install the fuse in the fuse holder (Figure 2).
Note: Your mower comes with a fuse in the your
owner's packet.
4. Install the battery cover.
Replacing the Fuse
If the battery does not charge or the engine does not
turn with the electric starter, the fuse may be blown.
Replace it with a 40-amp plug-in type fuse. Refer to
Installing the Fuse.
Form No. 3362-333 Rev A
Addendum
Figure 2
Original Instructions (EN)
Printed in the USA
All Rights Reserved