Rear Panel - Sony SRP-X351P Operating Instructions Manual

Names and Functions

Rear panel

1
1 ANT IN (antenna input) A/B terminals
Use to connect the antenna for wireless tuner. When
installing the tuner unit, connect the optional UHF
antenna WRU-801A/WRU-806A.
As these terminals output DC power of 9V for the
booster inside of the connected antenna, connection of
any antenna other than stated above may cause bad
performance or a malfunction.
(the max supply current is 20 mA)
Note
Before locating and connecting the antenna, read carefully the
instructions supplied with the antenna.
Incorrect location of the antenna may cause a bad reception
such as intermittent sounds. If it is not easy to relocate the
antenna after location, check carefully if the performance will
be satisfied with the location.
Use the coaxial cable of impedance 50 ohms/75 ohms (5D-FB,
5C-2V, etc.). The cable can be extended up to about 50 m with
5D-FB, and up to about 25 m with 5C-2V.
2 Tuner unit slot (MIC1, MIC2)
These are for installation of the optional 800MHz
wireless tuner unit WRU-801A/ WRU-806A. Up to
two units can be installed. (Refer to page 9 how to
install.)
Before installation, read carefully also the instructions
of WRU-801A/ WRU-806A.
6
2
!¡
8 9
0
5 6
3
4
!™ !£ !¢ !∞
!§
3 REMOTE terminals
CONTROL S input terminal
Connect to the S output terminal of another equip-
ment.
When this terminal is plugged in, the sensor of this
unit is not functioning.
Input signals are directly output from control S output
terminal.
CONTROL S output terminal
This terminal outputs the signal input from CON-
TROL S input terminal or the sensor.
RS-232C (serial input/output) terminal
Use to control this unit with a personal computer.
Connecting to a computer
Connect the computer to the RS-232C terminal of this
unit with a cross cable.
Terminal figure
Electrical specification : Based on RS-232C standard
Recommended cable
Cable length
1
6
Pin No. Signal
1 N.C
2 RD
3 TD
4 ER
5 SG
6 DR
7 RS
8 CS
9 N.C
7
: D-sub 9 pin, male,
inch type screw
: Plural leads shield cable for
data communication
: 15m or under
5
9
Function
Not connected
Received data
Transmission data
Data terminal ready
Signal line grand
Data set ready
Transmission request
Transmission approval
Not connected