Advertisement
by the user when configuring the handset e.g. ringer volume at 0F38, and some during normal
use of the phone e.g. redial memory at 0311..0392.
28.2. Introduction
The handset uses a 32k bit serial EEPROM (IC2) for storing volatile parameters. All parameters
are set up before the handset the factory. Some of these are vital for the operation of the
hardware so a set of default parameters is programmed before the actual hardware fine-tuning
can be initiated. This document lists all default settings with a short description.
This document lists all default parameters with a short description.
In the tables below values in a range that are similar are not repeated; i.e. Address 00 to 01
contains the value 00 simply means that the value 00 is repeated in all addresses in the range.
Type
Name
D
default
A
adjust
-
Country
x
Setting
28.3. EEPROM contents
28.3.1. General Setup
Address
Default
0000-0001
00, 00
0002
20
0030-0034
00
0036-003A
FF
003B-003F
FF
0040-0044
FF
0045-0049
FF
004A-004D
FF
28.3.2. Signal detection (for factory use only)
Description
The EEPROM location is preset to the Default value by the eeprom default
loader.
The EEPROM location is set during the production test and should not be
overwritten. The value is set by the eeprom default loader only if the location
contains 0xFF, i, e. it has never been set.
EEPROM location which is not set at all.
Default - no specific country setting, so revert to default value
Name
EepromOscillator
ModulationDeviation
IPEI (ID for Handset)
PARK_1 (ID for Base 1)
PARK_2 (ID for Base 2)
PARK_3 (ID for Base 3)
PARK_4 (ID for Base 4)
PLI_1-PLI_4
Type
A
Frequency adjustment
A
Mudulation adjustment
A
IPEI
-
PARK for registration 1
-
PARK for registration 2
-
PARK for registration 3
-
PARK for registration 4
D
Pli for registration 1-4. If set to FF
registration is deleted.
67
Description
Advertisement
