Signal Amplifier; Network Convertor For Lon Works - Fujitsu Airstage V-II Design & Technical Data

KINDS OF ADDRESS AND SETTING RANGE
„ „
UNIT SETTING
Touch panel
G Controller /
controller
Convertor
address
Network
H
convertor
Refrigerant
circuit address
Group remote
Group remote
I controller
controller
address
Wired, simple
Dual remote
J
remote
control switch
controller
Signal

Signal amplifier

K
amplifier address
Network
Convertor
convertor for M
address
L W
ORKS ®
ON
*Set up after confirming the details of each unit.
*1: The sum total of the Touch panel controller, Network convertor for Group remote controller and Network convertor
for L W ® is a maximum of 16.
ON ORKS
Note: Address of the Touch panel controller, Network convertor for Group remote controller and Network convertor
for L W ® must not be same.
ON ORKS
SETTING
TYPE OF SWITCH
RANGE
00 ~ 15
*1
Setting
example
01
0 ~ 99
SW 110
(10 digit) (1 digit)
00 ~ 03
ON/OFF SW 2 of DIP Switch 1
n Manual address setting
1 ~ 8
n Automatic address setting
Set to 1 at factory setting.
00 ~ 15
*1
- (06 - 68) -
REMARKS
See the setting method
See the setting method
SW 111
See the setting method
See the setting method
See the setting method
See the setting method
See the setting method
6-6-8
6-6-9
6-6-7
6-6-6
6-6-10
6-5-7
6-6-11