Table of Contents
Advertisement
2.5 Placement
•
Before using the cooler, remove all packaging materials including bottom
cushions, foam pads and tape inside, tear off the protective film on the
door and the cooler body.
•
The cooler should be placed in a well-ventilated indoor place on ground
that is flat and sturdy. (Rotate left or right to adjust the wheel for leveling, if
unstable)
•
Keep away from heat and avoid direct sunlight. Do not place the cooler in
moist or watery places to prevent rust or reduction of insulation.
•
Please leave at least 30 cm of space above the cooler, and 10 cm from
both sides and backside to facilitate heat dissipation.
2.6 Start to Use
•
The cooler must stand upright for half an hour before connecting power
when it is first started.
•
Clean the interior before using for the first time.
•
Do not connect the cooler to electronic energy saving plugs and converters
that can convert DC into AC (e.g.: solar energy system, ship grid).
•
When the compressor is running, there may be water drops or frost on the
backside of the cooler. Wiping out frost or water drops is not needed as the
water will be collected into drain tank, then inflow into water disposal pan
above the compressor and vaporized.
2.7 Energy Saving Tips
•
The cooler should be placed in a dry and well-ventilated room. The cooler
should not be placed in direct sunlight or next to a heat source (such as a
radiator, stove, etc.), and a suitable insulation board should be applied if
necessary.
•
Do not keep the cooler door open for too long.
8
Advertisement
Table of Contents
