Sanyo ECD-T1137S Owner's Manual
  1. Manuals
  2. Brands
  3. Sanyo Manuals
  4. Car Receiver
  5. ECD-T1137S
  6. Owner's manual

Sanyo ECD-T1137S Owner's Manual

Pll synthesized stereo radio with digital compact disc player
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
OWNER'S
MANUAL
ECD-T1137S
PLL Synthesized Stereo Radio with
Digital Compact Disc Player
1pair of RCA output
CD-R/CD-R W Compatibility
4 preset Equalization
Auxiliary Input

Advertisement

Table of Contents
loading

Related Manuals for Sanyo ECD-T1137S

Summary of Contents for Sanyo ECD-T1137S

  • Page 1 OWNER'S MANUAL ECD-T1137S PLL Synthesized Stereo Radio with Digital Compact Disc Player 1pair of RCA output CD-R/CD-R W Compatibility 4 preset Equalization Auxiliary Input...

  • Page 2: Installation

    INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver . • Before finally installing the unit, connect the wiring temporarily and make sur e it is all connected up properly and the unit and the system works properly. •...

  • Page 3: Din Rear-Mount (Method B)

    (Fig. 2) Removing the unit DIN REAR-MOUNT (Method B) Installation using the screw holes on the sides of the unit. 1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Screw (5 x 14mm) 5. Screw 6. Strap Be sure to use the strap to secure the back of the unit in place.

  • Page 4: How To Remove And Install The Front Panel

    HOW TO REMOVE AND INSTALL THE FRONT PANEL (OPTIONAL) 1. Press the release button and pull-of f the front panel. Store front panel in the case. 2. To install the front panel, insert the panel into the housing and make sure the panel is properly installed, otherwise, abnormalities may occur on the display or some keys may not function properly.

  • Page 5: Wiring Connection

    WIRING CONNECTION ANTENNA CONNECTOR IGNITION SWITCH (B+) YELLOW MEMORY BACK-UP BLACK GROUND (B-) BLUE POWER ANTENNA WHITE FRONT Lch SPEAKER WHITE/BLACK GREEN REAR Lch SPEAKER GREEN/BLACK MAIN UNIT (GREY) RCA CABLE GREY GREY/BLACK VIOLET VIOLET/BLACK Rch RED Lch WHITE FRONT Rch SPEAKER REAR Rch SPEAKER...

  • Page 6: General Operation

    OPERATION GENERAL OPERATION ON/OFF Switch on the unit by pressing any button [except (4)]. When system is on, press PWR button (9) to turn off the unit. FACEPLATE RELEASE Press button (7) to detach the removable faceplate. 6 16 button (7) and eject button...
  • Page 7 The adjustment mode will change in the following order: Volume Bass Treble Balance Fader By pressing VOL button + (11) or VOL button - (12), it is possible to adjust the desired sound level. LOUDNESS Press BND/LOU button (13) for several seconds to reinforce the bass output and display will show "LOUD".

  • Page 8: Automatic Memory Storing & Program Scanning

    RADIO OPERATION BAND SELECTION At tuner mode, press BND/LOU button (13) to select the desired band. The reception band will change in the following order: STATION SELECTION Press MANU/SKIP button (16) or MANU/SKIP automatic seek function. To select manual tuning mode, press for several seconds until "MANUAL"...
  • Page 9 CD play starts from when you release the button. PAUSE PLAYING Press PAU button (20) to pause CD player. Press it again to resume play. REPEAT THE SAME TRACK Press RPT button (22) to continuously repeat the same track. Press again to stop repeat.
  • Page 10 Note: A. Notes on discs: 1. Attempting to use non-standar d shape discs (e.g. square, start, heart) may damage the unit. Be sure to use round shape CD discs only for this unit. 2. Do not stick paper or tape etc., onto the label side or the recording side of any discs, as it may cause a malfunction.

  • Page 11: Specification

    Power Supply Requirements Chassis Dimensions Tone Controls - Bass (at 100 Hz) - Treble (at 10 KHz) Maximum Output P ower Current Drain CD PLAYER Signal to Noise Ratio Channel Separation Frequency Response RADIO Frequency Coverage Sensitivity (S/N = 30 dB)

  • Page 12: Troubleshooting

    TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your near est service dealer. Symptom Cause No power. The car ignition switch is not on. The fuse is blown.
  • Page 13 In order to obtain warranty service, the product must be delivered to and picked up from an Authorized Sanyo Factory Service Center at the user's expense, unless specifically stated otherwise in this warranty. The names and addresses of Authorized Sanyo Service Centers may be obtained by calling the toll-fr ee number listed below.
  • Page 16 21605 Plummer Street Chatsworth, CA91311 ECD-T1137S. Issue Number 1. Printed in Hong Kong 88-C1007-11...

Table of Contents