Connect Telephone Cables - Canon imageCLASS MF4680 Starter Manual

Connect the Power Cord, Turn On the Machine
1
Main power switch
Connect the power cord into the rear socket on
the back side of the machine and the wall outlet,
and press the [I] side of the main power switch to
ON.
What if...
● <TONER COVER OPEN/CLOSE COVER> is displayed:
Make sure that the toner cover and scanning platform are closed properly. (See "Install Toner Cartridge," on p. 5.)
● <TONER IS NOT SET/INSERT TONER> is displayed:
Make sure that the toner cartridge is installed properly. (See "Install Toner Cartridge," on p. 5.)
● <LOAD PAPER/CASSETTE :A4> is displayed:
Make sure that paper is loaded in the machine. (See "Set Up the Paper Cassette and Load Paper," on p. 7.)
WARNING
This product emits low level magnetic flux. If you use a cardiac pacemaker and feel abnormalities, please move away
from this product and consult your doctor.
NOTE
– During electrical storms, disconnect the power cord from the power outlet. (Please note that any documents stored
in the machine's memory will be deleted when you unplug the power cord.)
– Whenever you unplug the machine, wait at least five seconds before you plug it in again.
– Do not plug the machine into an uninterruptible power supply (UPS).
11
2
Ex.
1 0 0 % A 4
0 1
T E X T / P H O T O
The machine enters the standby mode.

Connect Telephone Cables

A
B
Connect the optional handset to the handset jack
(A) on the back side of the machine.
Connect your external telephone to the external
device jack (B) on the back side of the machine if
required.
Connect the supplied telephone cable to the
telephone line jack (C) on the back side of the
machine and the wall jack.
12