Install The Remote Control Batteries; Connect The Antenna Or Cable - Philips 19PFL3403D User Manual

3. Firmly pull the stand from the bottom of the TV.
Place both the stand and bolts in a secure
location for future reinstallation.
Step 3 Connect cables
Connect the antenna cable, AC power cord and all
other devices to the back of the TV as described in
the following sections and in Section 8 Connect devices.
Step 4 Secure the VESA-compatible wall
bracket to the TV
Warning
B
Only use the specified bolts (M4 x 10mm)
to secure the VESA-compatible wall
bracket to your TV. The specified bolts are
designed to match the weight of your TV.
Note
D
Depending on your VESA-compatible wall
bracket, you may need to separate the mounting
plate from the wall bracket for easier installation.
Refer to your VESA-compatible wall bracket
documentation for instructions.
100x100 mm
EN-8
4.3 Install the remote control
1. Open the battery cover on the back of the
remote control.
2. Insert the 2 batteries supplied. Make sure the
+ and - ends of the batteries line up correctly.
(inside of case is marked).
3. Close the cover.
4.4

Connect the antenna or cable

This section describes how to connect your TV to
an antenna, cable, Direct Broadcast Satellite, and to a
cable receiver box.
HDMI 1
PC IN
HDMI 2
VGA
AUDIO IN
Connect to an antenna
Any DTV programs that are broadcast in your area
can be received for free through an antenna
connection.
Contact your local content provider or your local
electronics retailer if you are unsure about what
HDMI 1
PC IN
HDMI 2
VGA
HDTV programs are available in your area. AUDIO IN
Broadcasters are transition from analog to digital
TV. This means that a given broadcaster can have
channels available either in analog or in digital, or
both analog and digital at the same time.
The TV has stereo sound if the broadcasting channel
makes it available.
ANTENNA
HDMI 1
PC IN
HDMI 2
VGA
AUDIO IN
75 Ω
batteries
CABLE
75 Ω
75 Ω
SATELLITE
SATELLITE CABLE
OR
OR