Table of Contents
Advertisement
Troubleshooting
WARNING
Under no circumstances should you try to repair this unit yourself, as this invalidate the
warranty. Do not open this unit as there is a risk of electric shock.
If a fault occurs, fi rst check the points listed below before taking this unit for repair. If you
are unable to remedy a problem by following these hints, consult your dealer or Philips for
help.
Problem
No power.
No picture.
Completely distorted picture
or black/white picture.
36
1_dvp1120-2008_93_eng1_final813.36 36
1_dvp1120-2008_93_eng1_final813.36 36
Solution
– Press 2 on the unit to turn on the power.
– Ensure that the AC outlet have power.
– Disconnect the power cord from the power outlet
for a few minutes. Reconnect the power cord and try
to operate again as usual.
– Refer to your TV manual for correct Video In channel
selection. Change the TV channel until you see the
DVD screen.
– If this happens when you turn on the progressive scan
feature, wait for 15 seconds for the auto recovery or
switch back to the default mode as below:
1) Press ç on this unit.
2) Press and hold numeric keypad '1' on the remote
control.
– If this happens after you set the colour system, wait
for 15 seconds for the auto recovery or switch back
to the default TV colour system:
1) Press ç on this unit.
2) Press and hold numeric keypad '3' on the remote
control.
– Check the video connection.
– Ensure that the disc is compatible with this unit.
– Sometimes a small amount of picture distortion may
appear. This is not a malfunction.
– The disc is dirty. Clean the disc.
2008-03-24 2:43:18 PM
2008-03-24 2:43:18 PM
Advertisement
Table of Contents
