Panasonic KX-HCM280A Operating Instructions Manual page 58

Operating Instructions
Phase 2
The camera does not support aggressive mode.
*1
• Set up the IPsec policy as the following.
Items
Protocol
Source Network
Source IP address
Destination Network
Destination IP address A global address of the camera
9.
Access the camera (see page 11).
• If you can access the camera, the IPsec setup is complete.
Note
• In IPsec communications, "IPsec" is displayed on the Top page or the
Single Camera page.
• If you cannot communicate using IPsec, see 2.7 IPsec in the
Troubleshooting section of the Installation/Troubleshooting.
• See the Panasonic Network Camera support website at
http://panasonic.co.jp/pcc/products/en/netwkcam/ for the IPsec
features.
58
IKE Items
Mode
PFS
Cipher Algorithm
Message-Digest
Algorithm
Lifetime
ANY
Network address and subnet mask on the LAN side of the
VPN router
A global address on the WAN side of the VPN router
A global address of the camera
Settings
Quick mode
Specifies either of Off, D-H Group 1 or D-
H Group 2.
Select from DES-CBC, 3DES-CBC,
AES-CBC (128, 192, 256 bits) or NULL.
(Multiple selections are available.)
HMAC-MD5-96, HMAC-SHA-1-96
Specifies by 28800 s (Byte setting is not
supported.)
Settings