Specifications - Black & Decker BDXPA0021 Instruction Manual

2-Pack Grounded Indoor Outlet Timers
WARNING:
FOR INDOOR USE ONLY. DO NOT EXCEED RATED CAPACITY.
-For indoor use only.
-Keep away from children.
-Do not use with any appliance that exceeds the rating capacity of the timer.
-Always ensure that the plug of controlled device is fully inserted into the timer.
-Clean only with a dry cloth. Do not immerse in water or any liquid.
-Appliances should not be left unattended.
-It is strongly recommended that the timer is not to be used to control heaters or other devices
with heating elements (cooking appliances, fans, irons, etc.).
1. Setting the On/Off periods
This timer can set up to 48 On/Off commands a day.
Using your finger, a pen or screwdriver pull up all the segments that correspond to the
desired "Off" period. For the desired "On" period, make sure the segments are pushed down.
Each segment represents 30 minutes: 2 segments = 1 hour.
2. Setting the time
Turn the dial clockwise until the triangular pointer is pointing at the actual time. Ensure that
the switch on the side of the unit is set to the TIMER ON position.
3. Connection
Once the desired On/Off periods and actual time are set, plug the Timer into the wall socket,
and then the appliance's plug into the Timer. Ensure the wall socket and the appliance is on.
The Timer will start to operate and switch on and off the appliance according to the pre-set
On/Off commands.
4. Manual On/Off
The pre-set On/Off commands can be interrupted by using the manual override switch. When
switched to the TIME ON position, the connected appliance is switched on permanently. To
reactivate the timer's control of the appliance, turn the appliance switch on and set the timer's
override switch to TIMER ON. In case of power failure, reset the timer as explained in Step 2.

5. Specifications

Rating: 125Vac, 60Hz
Max.Power: 15A, 1875W Resistive, 1250W Tungsten, 1/2Hp
Temperature: 0 C~55 C
4