Programming The Timer - Black & Decker BDXPA0022 Instruction Manual

2-Pack Polarized Indoor Digital Bar Timers
WARNING
1. This timer uses a rechargeable battery. To power back on, press the reset button when
the timer is plugged into outlet.
2. Risk of electric shock:
-Keep away from children
-Clean only with a dry cloth. Do not immerse in any liquids.
-Ensure that the plug for the powered device is fully inserted into the timer
-Do not use in wet locations, the timer is for indoor use only
3. Risk of fire:
-Do not use to control appliances that contain heating elements (cooking appliances,
fan, irons, etc.)
-Do not exceed electrical rating
4. Specifications
•125V~ 50-60Hz, 15A for Resistive
•125V~ 50-60Hz, 10A for Tungsten
Any changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Use of an extension cord with this product is not recommended.
BEFORE YOU BEGIN PROGRAMMING THE TIMER:
This timer has an internal battery backup to save all programming.
1. Plug timer into a wall outlet for 30 minutes to charge the internal battery.
2. After 30 minutes, unplug timer and press R button with the tip of toothpick or similar object
to clear the memory.

PROGRAMMING THE TIMER

Set time/day:
Press and hold CLOCK while you press HOUR and MINUTE to advance the display to the
correct time. To change from AM to PM, press and hold CLOCK while you press HOUR 12
times. Press and hold CLOCK while you press DAY until correct day is displayed.
To program the first ON/OFF cycle:
1. Press PROGRAM to display ON 1 setting
2. Press HOUR and MINUTE to set ON time. To change from AM to PM, press HOUR 12
times.
3. Press DAY to select the desired day (or days) for the first ON time.
4. Press PROGRAM to display OFF 1 setting. Repeat steps 2 and 3 to select OFF time and
day(s).
To program additional ON/OFF cycles: Repeat steps above to create additional ON/OFF
cycles (ON 2-OFF 2, ON 3-OFF 3, etc.) up to a maximum of 20 different ON/OFF cycles.
Once all ON/OFF cycles are programmed correctly, press CLOCK to exit programming
mode.
4