Nokia N93 Manual page 241

Security settings for
Wep key in use—Select the WEP key number. You can
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.
Authentication
authentication type between your device and the wireless
LAN access point device.
WEP key settings—Enter
key), WEP key format (ASCII
key (the WEP key data in the selected format).
Security settings for
follows:
WPA mode—Select the means of authentication:
use an extensible authentication protocol (EAP) plug-in or
Pre-shared key
appropriate settings:
EAP plug-in settings
your service provider instructs.
Pre-shared key
password. The same password must be entered on the
wireless LAN access point device.
TKIP encryption—Select whether Temporal Key Integrity
Protocol (TKIP) is used.
Homepage—Define a home page.
108
WEP are as follows:
type—Select Open or Shared
WEP encryption (length of the
or Hexadecimal), and
802.1x and WPA/WPA2
to use a password. Complete the
(only for EAP)—Enter the settings as
(only for Pre-shared key)—Enter a
Select Options
following:
IPv4 settings:
device), Subnet mask
gateway (the gateway), and
for the
addresses of the primary and secondary DNS server.
Contact your internet service provider for these addresses.
IPv6 settings
Well-known, or
WEP
Ad-hoc channel
number (1-11) manually, select
are as
Proxy serv. address—Enter the address for the proxy
server.
EAP to
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data
are in a network that supports packet data, the device
registers to the packet data network. Starting an active
packet data connection (for example, to send and receive
e-mail) is quicker. If there is no packet data coverage, the
device periodically tries to establish a packet data
connection. If you select
> Advanced settings and from the
Phone IP address (the IP address of your
(the subnet IP address),
DNS address—Enter the IP
> DNS address—Select Automatic,
User defined.
(only for Ad-hoc)—To enter a channel
User defined.
conn.—If you select When available
When needed, the device uses a
Default
and you