Table of Contents
Advertisement
Chapter 3 Basic Operation
3.1. Setting the Print Position
Set the print position in the following steps.
1.
Open the print cartridge cover.
2.
Move the print cartridge to an appropriate
printing position.
Hold the print cartridge, as below, and slide it to the left or
right within the document width to set it at a suitable print
starting position.
HINT
●
The triangle-shaped protrusion on the print cartridge
holder indicates the print head. Use the protrusion as a
guide for the print position.
●
The document size markings are on the upper side of the
print cartridge. Use the markings as a guide for the
document width.
●
Load the actual document in the scanner and make sure
that the print cartridge is positioned within the width of
document.
3.
Close the print cartridge cover.
3.2. Print Setup
You can configure settings for the imprinter by using the
scanner driver
s setup window.
'
HINT
How to run the scanner driver differs depending on the application.
For details, refer to the manual or help of the application being
used.
HINT
The following items can be specified. For details, refer to the help
of the PaperStream IP driver.
●
Imprinter status (on or off)
●
Whether the PaperStream IP driver is synchronized with the
Digital Endorser
●
Printing settings (such as font type, direction, the print starting
position, character strings to be printed, and initial, increased
and decreased values for the counter)
3.3. How to Use the Stacker Tab
Use the stacker tab when the document could not be
ejected smoothly.
1.
Raise the stacker.
2.
Lift up the stacker tab (one on each side).
3.
Put back the stacker.
2
fi-748PRB Imprinter Operator's Guide |
3
1
2
9
Advertisement
Table of Contents
