Summary of Contents for Honeywell Ex-Or UC1200PF
- Page 1 LightSpot Washroom Series UC1200PF Installation and Commissioning Instructions Note: HP2000 (or HP10*/HP18*) required for commissioning * Please note that the HP10 and HP18 offer different/limited programming options...
- Page 2 LightSpot presence-detecting washroom control Only suitably qualified personnel should install this equipment. This is a high performance presence detector with photocell. The photocell can operate in three modes: Passive, Active or Disabled. Further information can be found overleaf. Fixing The UC1200PF is suitable for flush mounting in a suspended ceiling tile, maximum 54mm thick and with a minimum clearance of 125mm between the front surface of the tile and the hard ceiling behind.
- Page 3 HP10 Parameter Options for UC1200PF MOVEMENT Please note that additional PHOTOCELL DETECTOR parameters are available via MODE 24 Hr Cycle AUTOMATIC the HP2000 Programmer. = ACTIVE POWER UP OPERATION PHOTOCELL USED ENABLED OFF DELAY OFF DELAY PHOTOCELL * If controlling water, the Add together to give required time.
- Page 4 Setting the Photocell 1. Wait until the time of day when the ambient light level is equal to the level at which you want the photocell to become active. 2. Using the HP2000, select ‘Set Light Level’ from the Utilities menu and press OK while pointing at the detector to store the current light level - the lights must be on prior to starting this process.