Connecting The Cables - JVC CL-S500 Series Installation Manual

Connecting the cables

1
Turn off the computer.
2
DVI-D connection :
Connect the supplied DVI cable between the monitor's DVI-D and the computer's
DVI output connector.
DisplayPort connection :
Connect the DisplayPort cable between the monitor's DisplayPort_IN and the
computer's DisplayPort connector.
Supplied cable use is recommended. If you don't use it, the monitor may
Note
become unstable and the screen may flicker.
3
Connect the provided USB cable to the "UP" stream port on this product and the
"DOWN" stream port on the computer (or other USB hub) when the product is
controlled (configuration change or quality control) by the computer.
4
Connect the supplied power cable between the AC inlet and the wall outlet.
5
Turn on the monitor and the computer.
I N C A
For use in the U. S.
For use in Europe
Caution
- This product is intended to be connected to an IEC 60601-1 certified device. To
use this product without connecting to such a device, it needs to be evaluated
according to the requirements of IEC 60601-1 and IEC 60601-1-1.
- Use the supplied power cord only.
DisplayPort cable
or DVI cable
2
3
4
- 5 -