Installation - Smeg D3140P User Manual

Problem
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).

INSTALLATION

Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Possible cause
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
3. Replace the used lamp with a new lamp
of the same power and specifically
designed for household appliances (the
maximum power is shown on the lamp
cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised
Service Centre.
Cli-
mate
class
SN
N
ST
Solution
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
45