Table of Contents
Advertisement
Getting Started (Videotapes)
STEREO is the normal factory setting because it works for both stereo and mono
broadcasts. It is also necessary for recording a second audio program (SAP).
When you select MONO, sound is recorded as mono even when a channel broadcasts
in stereo.
Use the MONO setting when the stereo signal is not strong enough for quality
reception (for example, when there is signal drift or noise).
Getting Started (Videotapes)
About Videocassette Tapes
Types
The best thing you can do for your VCR is use the best quality tapes available. This
VCR uses S-VHS or VHS tapes only, which are the most common type. Look for the
S-VHS or VHS mark on new or prerecorded tapes you buy.
Tapes are marked T-120, ST-120, T-160 or ST-160, which signifies how many minutes
of programming they can hold at standard recording speed (SP). To get the best
quality picture, record at standard speed. But if you want to get more on a tape and
are less concerned about the quality, set the VCR for extended play (EP).
TYPES
T-120/ST-120
T-160/ST-160
You may have noticed that there is also an LP speed. You Hitachi VCR does not
record at this speed, but it can play cassettes that were recorded in LP mode. No
special setting is required for playback.
Safety Tabs Prevent Erasure
A safety tab is located on the front left edge of every videotape next to the label.
Break this tab off if you want to keep a special tape from being erased accidentally.
(Notice this tab is already removed on prerecorded tapes you buy or rent.) Poke a
screwdriver or similar tip into the space behind the tab to break it off.
Don't worry, you can change your mind and record on this tape even after the tab is
broken off - simply cover the hole with cellophane tape.
Tape Capacities at Different Speeds
RECORDING TIME
SP
EP
120 min.
160 min.
360 min.
480 min.
- 25 -
Advertisement
Table of Contents
