Specifications; General Power Tool Safety Warnings - Makita UH200D Instruction Manual

ENGLISH (Original Instructions)
1. Battery cartridge
2. Buttons
3. Lock-off button
4. Switch trigger
5. Indication lamp
6. Cutting height
7. 10 cm
8. Trimming direction
9. Tilt the blades
10. Hedge surface to be trimmed
11. String
12. Clamping nuts
13. Chip receiver
14. Screws on the shear blades
15. Blade cover to be always installed
before installing the chip receiver

SPECIFICATIONS

Strokes per minute (min
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............... Take particular care and attention.
...... Read instruction manual.
............... Danger; be aware of thrown objects.
............... Keep bystanders away.
............... Cutting means continues to run after the
motor is switched off.
Explanation of general view
16. Brush
17. Machine oil
18. Blade cover
19. Undercover
20. Locking lever
21. Press
22. Turn
23. Screws
24. Crank
25. Shear blades
26. Basic alignment line on the tool
housing
27. Pins
28. Apply grease
29. Recessed part of crank
30. Oval holes that are overlapped
Model
Blade length
-1
)
Net weight
............... Do not expose to moisture.
END010-5
Intended use
The tool is intended for trimming hedges.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
31. Hole in the base plate of shear
blades
32. Base plate
33. Bent part of the base plate of
shear blades
34. Groove in the undercover
35. Hook hole
36. Grass shear blade
37. Grass shear blade cover
38. Storage case
39. Base frame
40. Groove
41. Change lever
42. Protrusion on base frame
UH200D
200 mm
1,250
460 mm
1.1 - 1.2 kg
D.C. 10.8 V
BL1013
DC10WA
ENE014-1
GEA006-2
9