Honeywell DESIGNER HPA830 Series Owner's Manual page 9

USING THE AROMATHERAPY TRAY
This Designer Series Air Purifier features an Aromatherapy Tray (Essential oils not included).
Follow the steps below to use the Aromatherapy feature on your Designer Series Air Purifier.
Add Essential Oil to the Aromatherapy Tray:
1. Open the cover of the Aromatherapy Tray.
2. Place cotton ball or other absorbing material (not included) into the tray.
3. Add a few drops of your favorite essential aroma oils (not included) onto the material.
4. Once essential oils have been added, replace the cover by aligning the larger tab
with the large slot and then pressing down until it snaps in place.
Aroma will be infused with the cleaner air being returned back into the room while the unit is in use.
1
Note: The use of scented aromatherapy oil may trigger the VOC to illuminate yellow or red under the unit
and cause the unit to operate at a higher speed on AUTO mode.
CLEANING THE AROMATHERAPY TRAY
The aromatherapy tray can be removed from the unit for easier cleaning.
1. To clean the aromatherapy tray, remove the aromatherapy tray cover, and discard the absorbent
materials or cotton.
2. Twist the essential oils tray counter-clockwise (to the left) until it loosens, then lift it out of the unit.
3. Wipe down the tray and wash it under clean tap water until it is clean.
4. Insert clean essential oils tray and replace into the unit by aligning the tabs and twisting clockwise
(to the right).
5. Add new cotton or other absorbent material and add a few drops of essential oils if desired and replace
the cover as directed above.
1
4
2
2
5
3
3
9
4