GE AHTK18BA Owner's Manual & Installation Instructions page 4

Controls
Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel
indicate the selected settings.
1 2
Air Conditioner Controls
1. Power Pad
Turns air conditioner on and off. When turned on,
the display will show the Set temperature.
2. Display
Shows the Set temperature or time remaining on
the temperature in Cool or Eco modes.
3. Temp and Delay Increase + /Decrease – Pads
Use to set temperature or delay time. Temperature
can be set in Cool and Eco mode.
4. Mode Pad
Use to set the air conditioner to Fan Only, Cool, or
Eco mode.
5. Fan Speed Pad
In Cool or Eco mode: Use to set the fan speed to
Auto, High, Med or Low on the unit.
In Fan Only mode: Use to set the fan speed to
High, Med, or Low on the unit.
6. Delay Pad (set by remote control only)
Delay ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours at its
previous mode and fan settings.
Delay OFF—When the air conditioner is on, it can
be set to automatically turn off in 1 to 24 hours.
How to set:
Press the Delay pad on the remote control. Each
Increase + /Decrease –
touch of the
remote control will set the timer in 1-hour intervals.
To review the remaining time on the Delay timer,
press the Delay pad on the remote control. Use
Increase + /Decrease –
the
control to set a new time if desired.
To cancel the timer, press
remote control until the set time is zero.
4
3 4
+
MODE COOL FAN ECO
–
SPEED AUTO LOW MED HIGH
5
pads on the
pads on the remote
Decrease –
pad on the
8 7
FILTER SLEEP
WIFI
Solid light indicates SmartHQed
9
Blinking light indicates
connecting
See Appliance Communication
section in this manual
7. Sleep Pad (set by air conditioner controls only)
The SLEEP mode sets the unit to gradually change
settings over an 8 hour period to allow for some
increased energy efficiency during sleep hours.
The SLEEP mode is available only in COOL and
FAN only settings.
Press the SLEEP mode pad and its light will
illuminate. The fan indicator will stay at the same
setting but the air conditioner will automatically
change the FAN speed to low in either COOL or
FAN only mode.
In FAN only mode, the fan will stay in the LOW
speed setting for 8 hours. After 8 hours, the air
conditioner will resume the settings that were in
place before the SLEEP mode pad was pressed.
In COOL mode, the fan will stay in the LOW speed
setting for 8 hours from the time the SLEEP mode
pad was pressed. The air conditioner will also
raise the set point 2°F in 30 minutes and 2°F more
in another 30 minutes where it will remain for the
next 7 hours. After 8 hours, the air conditioner will
resume the settings that were in place before the
SLEEP mode pad was pressed.
While the unit is in SLEEP mode, pressing any pad
will return it to the settings that were in place before
the SLEEP mode pad was pressed.
8. Filter Reset Pad
This feature automatically notifies you that the air
filter must be cleaned. The indicator light will come
on after 250 hours of operation. Clean the air filter
(refer to page 7), place it back in the front panel,
and press the Filter Reset pad. The light will go off.
9. SmartHQ Pad
Enables connection of the air conditioner to the
home WiFi.
Download the SmartHQ App
For details go to GEAppliances.com.
1
Power
5
Speed
3
4
Mode
6
Eco Delay
Remote Control
49-5000610 Rev. 0