How To Change The Bulb; Electrical Connection - AEG 200372733 Instruction Book

How to change the bulb

Should the light fail to work you can change it as below:
Disconnect from the electricity
supply.
Press the rear hook (1) of the lam-
pcover by a screwdriver and at the
same time pull and rotate the cover
in the direction indicated by the
arrow (2). So the bulb can be
replaced. (Bulb type: T25 Daylight
230-240 V, 25 W, E 14 thread)
After changing the bulb replace
the cover, snap it in place and
reconnect the electricity supply.

Electrical connection

This refrigerator is designed to operate on a 230 V AC ( ~ ) 50 Hz supply.
The plug must be put into a socket with protective contact. If there is no
such, it is recommended to get an electrician to fit an earthed socket in
compliance with standards near the refrigerator.
This appliance complies with the following E.E.C. Directives:
73/23 EEC of 19.02.73 (Low Voltage Directive) and subsequent modifica-
tions,
89/336 EEC of 03.05.89 (Electromagnetic Compatibility Directive) and
subsequent modifications.
- 96/57 EEC - 96/09/03 (Energy Efficiency Directive) and its subsequent
amendments
27