Table of Contents
Advertisement
Installation
Notes:
• The following installation instructions refer to an installation in which two media
converters are used.
• To avoid damage due to Electrostatic Discharge (ESD), it is recommended you
handle the product while wearing an ESD wrist grounding strap or by touching
a conductive surface (such as metal) to discharge any potential ESD prior to
handling the product.
1. Using Cat5e/6 cable, connect the RJ45 port on the media converter to
your network.
2. Connect a transceiver (such as Tripp Lite's N286-Series) to the open
SFP port on the media converter. Then connect fiber cabling matching
the transceiver type to the transceiver's port, as well as a second
matching transceiver and media converter.
3. Using Cat5e/6 cable, connect the RJ45 port on the second media
converter to your network device (workstation, hub, switch, etc.).
4. Connect the external power supplies included with each media
converter and plug them into a power source.
3
Advertisement
Table of Contents
