WARNING: Read and understand all other than those specified in this manual may result in hazardous laser radiation instructions. Failure to follow all exposure. instructions listed below may result in The label on your tool may include the electric shock, fire and/or serious personal following symbols.
Assembly / Set-up Vertical Mounting The wall / tabletop mounting bracket uses push pins or a screw hole to secure it to a vertical surface. CAUTION: Pins are sharp and should be handled with care. NOTE: The pins are only for use when hanging the bracket on drywall, NOT other surfaces including plaster.
Pull out with even CAUTION: Make sure laser is securely suspended by the strap. force on both pins. To hang, thread the strap through the slot in the top of the laser and fasten the hook as shown in figure 9. Adjust the laser so that it hangs relatively straight.
Problem Possible Cause Solution • Weak battery. • Replace with fresh battery. • Laser does not project on wall or laser beam dim. • Be sure that the unit is as • Laser lines are • The self leveling range straight up and down as projected as a dashed of the unit is +/-5...