Track Alignment - Polaris 340 LX 2007 Service Manual

2007-2012 edge/widetrak lx snowmobile
Hide thumbs Also See for 340 LX 2007:
Table of Contents

Advertisement

Maintenance

Track Alignment

NOTE: Track
alignment
Misalignment of the track will cause excessive wear to
the track, rail slides, and rail.
NOTE: Excessive rail slide wear occurs due to
running in inadequate snow conditions.
Periodically check that the track is centered and running
evenly on the slide rails. Misalignment will cause
excessive wear to the track and slide rails.
1. Safely lift and support the rear of the snowmobile off
the ground.
2. Rotate the track by hand to check for any possible
damage.
3. Inspect the track rods (A) carefully and examine the
track along the entire length of each rod, bending the
track edge and inspecting it for breakage. If any rod
damage is found, the track should be replaced.
4. Warm up the track by starting the engine and apply a
small amount of throttle so the track runs slowly at
least five complete revolutions.
5. Stop the engine and turn the ignition off.
6. Inspect track alignment by carefully looking through
the track window (B) to make sure the rails (C) are
evenly spaced on each side.
7. If the track runs to the left, loosen the left locknut and
tighten the left adjusting bolt (D). If the track runs to
the right, loosen the right locknut and tighten the right
adjusting bolt. It may be necessary to check this with
the engine rotating the track. Be sure to SHUT THE
MACHINE
OFF
adjustments.
8. Loosen up the rear idler shaft (F).
3.22
affects
track
tension.
before
making
any
9923396 - 2007-2012 EDGE/Widetrak LX Service Manual
A
B
C
9. After any adjustments are complete, torque the
locknuts (E) to 35 ft-lb (48 N-m).
Adjuster Lock Nuts: 35 ft-lb (48 N-m)
10. Torque both idler shaft bolts (F) to 35 ft-lb (48 N-m).
Idler Shaft Bolt: 35 ft-lb (48 N-m)
Broken track rods can cause a rotating track to come off
the machine. Never operate or rotate a damaged track
under power with a broken rod. Serious injury or death
Stay clear of all moving parts to avoid personal injury.
Never make any adjustments with the engine running,
as serious personal injury can result.
further
©2011 Polaris Sales Inc.
F
D E
= T
= T
WARNING
may occur.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents