Installing The Cooktop - GE JP655SMSS Installation Instructions Manual

INSTALLING THE COOKTOP

INSTALLING THE
1
JUNCTION BOX
Install an approved junction box where it will
be easily reached through the front of the
cabinet where the cooktop will be located.
The cooktop conduit is 4 feet long.
Install junction box so
that it can be reached
through the front of
the cabinet.
IMPORTANT:
must be located where it will allow
considerable slack in the conduit for
serviceability.
PROTECT SURFACE
2
OF COOKTOP
Place a towel or tablecloth onto the
countertop. Lay the cooktop upside down
onto the protected surface.
Bottom of cooktop
Cloth under Cooktop
Installation Instructions
16"
Min.
The junction box
ATTACH FOAM TAPE
3
Apply the foam tape around the outer edge of
the glass. Do not overlap the foam tape.
Bottom of Cooktop
Cooktop
Glass
Note: On PP962S, PP972S, PP975S & PP980S
models, apply the foam tape around the outer
edge of the glass on the sides and rear of the
unit only.
LOCATE MOUNTING PARTS
4
Remove the Hold Down Brackets and screws
from the literature package.
Mounting Screw
5 ATTACH BRACKETS
TO COOKTOP
Screw the Hold Down Bracket to the side
of the cooktop unit. Repeat for opposite side
of cooktop.
Bottom of Cooktop
Cooktop Glass
5
Foam Tape
Pre-Drilled Hole
Foam Tape
Hold Down
Bracket