Canon VB-C500D Start Manual page 51

Use of External Power Supply
Connect the bundled power interface cable (WP500-VB) as shown below.
Power interface cable
Use a 12-VDC or 24-VAC power supply insulated from 100 VAC.·
12 VDC can be connected in a non-polar condition.
Use the power supply within the following voltage range.
24 VAC: Voltage fluctuation within 24 VAC±10%
(50 or 60 Hz within ± 0.5 Hz)
Current supply capacity per camera 0.23 A
12 VDC: Voltage fluctuation within 12 VDC±10%
Current supply capacity per camera 0.36 A
* If a 12-VDC battery power supply is used, be sure to connect a resistor of 0.5 to 1.0Ω/20 W
or more to the power line.
Applicable wires and recommended power cable length
Applicable cable (AWG)
Conductor size ( mm, inch)
Maximum cable length, 12 VDC (m (ft))
Maximum cable length, 24 VAC (m (ft))
Use a UL cable (UL-1015 or equivalent) for wiring 12 VDC or 24 VAC.
Screwdriver
Tightening torque:
0.4N·m (3.54lbf·in) (max.)
Stripping length
Approx. 5 mm (0.20 in)
AC adapter
(single wire 1.0 mm
( 0.0039 in), stranded wire
1.2 mm ( 0.0047 in))
This completes the network connection.
Step 2 Connect the Camera to the Network
#18
( 0.051 in), stranded wire
23 (75.5)
46 (150.9)
#16
(single wire 1.3mm
1.6mm ( 0.063 in))
32 (105.0)
64 (210.0)
2-9