Advertisement
Quick Links
Installation
Instructions
Questions? Call GE Answer Center at 800.626.2000
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• For easier installation and personal safety, we
recommend that two people install this microwave oven.
• Unplug the microwave oven before attempting
installation of this kit.
FOR YOUR SAFETY:
WARNING –
installation, switch power off at service panel and lock
the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the
service panel.
TOOLS YOU WILL NEED
#2 Phillips screwdriver
Pencil
Awl or punch
READ CAREFULLY.
KEEP THESE INSTRUCTIONS
Save these
Observe all
Be sure to leave these
Keep these instructions
Before beginning the
" bit or #35
Drill with
7
⁄
64
Scissors (optional)
Tape measure
.
Built-In Trim Kits
JX2127 and JX2130
or
Visit our Website at:
• Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
• Completion time – 1-3 hours
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• This kit is UL listed for installation alone or over
any General Electric/Hotpoint/RCA single electric
wall oven.
PARTS INCLUDED
PART
1
www.GEAppliances.com
QUANTITY
Trim Frame
Bottom Duct
Top Bracket
Phillips Round-Head
Screws
(22 required
for installation)
Phillips Flat-Head
Screws
(4 required for
installation)
Anti-Tip Bracket
Bottom Bracket
Template
1
1
1
24
5
1
1
1
Advertisement
Related Manuals for GE JX2127SH
Summary of Contents for GE JX2127SH
-
Page 1: Installation Instructions
Installation Instructions Questions? Call GE Answer Center at 800.626.2000 BEFORE YOU BEGIN Read these instructions completely and carefully. IMPORTANT – • instructions for local inspector’s use. IMPORTANT – • governing codes and ordinances. Note to Installer – • Be sure to leave these instructions with the Consumer. -
Page 2: Cutout Dimensions
Carefully turn the microwave oven upside down. Line up the tabs on the bottom duct with the slots on the bottom of the microwave and insert the tabs into the slots. Secure the bottom duct with four bronze round-head screws as shown. - Page 3 Screws Install the anti-tip bracket onto the cutout floor using two bronze round-head screws. ″ down the face Slide the microwave oven part way into the cabinet ⁄ opening. Plug in the microwave oven. The bottom bracket must be flat to the cutout floor to engage correctly with the anti-tip bracket as shown.
- Page 4 INSTALL THE TOP BRACKET Place the top bracket on the top of the microwave oven, with the tabs on the top and sides of the bracket fitting squarely against the microwave oven. Tabs Screws Drill pilot holes through the holes in the top bracket.