Quick Start Instructions - Canon FB630U User Manual

Quick Start Instructions

Those who wish to start scanning immediately should follow the procedures below. If
you require further information at any stage, read the pages referenced at each step.
Installing Plug-in Module CS-U
1. Place the Macintosh version of the CanoScan Setup CD-ROM
1
1
2. Click [Install the Software] and install Plug-in Module CS-U.
Start Plug-in Module CS-U
1. Connect the scanner to the computer, then start Adobe
2
2
2. Select [CanonPI CS-U 3.3.0...] as the image source (this step is
3. Click the scanner icon.
Start the Preview Scan
1. Place the materials to be scanned on the scanner.
3
3
2. Click the preview scan button (
that came with the scanner into the computer's CD-ROM drive.
The CanoScan Setup Utility will automatically start. (If the
CanoScan Setup Utility does not automatically start, double-
click the [CanoScan FB630U/636U] icon, followed by the
[Setup] icon.)
(Install Adobe PhotoDeluxe 2.0 first.)
If Adobe PhotoDeluxe 2.0 has not yet been installed, install it
before Plug-in Module CS-U.
PhotoDeluxe 2.0.
only required the first time the scanner is used with the
program)
• Plug-in Module CS-U will start and display its control panel.
p. 21
• The entire document glass area will be scanned and displayed in the
preview scan window.
Plug-in Module CS-U automatically calibrates itself the first time the preview or
scan button is clicked. The scanner will run by itself for a few moments without
displaying an image in the window. This does not constitute a breakdown. The
calibration results are stored until the computer power is shut off.
p. 13
p. 19
).
Preview Window
9