Black & Decker BIMH326S Instruction Manual page 9

SET UP & USE
BEFORE USE
1. Remove the packaging, packaging material and tape.
2. Remove the ice basket and scoop. Clean the interior of the unit, basket and
scoop prior to use.
3. Put the ice maker on a flat level surface away from direct sunlight and other
sources of heat (i.e.: stove, furnace, radiator). Maker sure that there is at least
5"/13 cm clearance between the back and sides of the unit.
4. After transporting the unit, allow one hour for the refrigerant fluid to settle
before plugging the ice maker in.
WARNING: Fill with potable water only. Only use drinking water.
HOW TO USE
Do not use the appliance within 30 minutes after transportation. Switching on the
power too early might cause damage to your ice maker.
1. Open the lid, remove the ice basket and pour water into the tank. Keep water
level below the MAX fill line.
Press "ON/OFF"
2. Select the ice cube size by pressing the "SELECT"
temperature is lower than 60°F, it is recommended to select small ice cube in
order to avoid ice sticking together.
3. The ice making cycle lasts approx. 6 to 13 minutes.
4. If there is not enough water, the ice maker will stop automatically, and the
WATER SHORTAGE
water up to the max. water level mark and press "ON/OFF"
turn on the unit again.
NOTE: Wait at least 3 minutes before restarting the unit.
5. The ice maker stops when the ice basket is full and the "ICE FULL"
will be on. Use the scoop to remove the ice.
WARNING:
• Direct sunlight or sunlight reflection may cause the unit to malfunction.
• Change the water in the water tank every 24 hours to ensure a reasonable hygiene
level.
• If unit will not be in use, drain all the water, clean the water tank and dry it
thoroughly.
WARNING: Unplug unit before draining water, cleaning and drying.
NOTE: The ice cubes in the basket will melt gradually so use the scoop to remove the
ice cubes before they melt. The melted water will be collected into the water
tank. To remove the water in water tank, unplug the drain cap on the base of
the ice maker. Make sure to clean and dry the unit thoroughly and replace the
cap prior to use.
WARNING: Unplug unit before draining water, cleaning and drying.
on the control panel to begin the ice making cycle.
indicator light will go on. Press "ON/OFF"
button. If the room
button, fill
button again to
indicator
Page 9