Tire Inspection; Tire Pressure - Polaris RZR 800 2013 Manual

6. Torque the wheel nuts and/or hub nut to the proper
torque specification listed in the torque table at the
beginning of this section.
7. If hub nut was removed, install a new cotter pin after
the hub nut has been tightened.
CAUTION
If wheels are improperly installed it could affect vehicle
handling and tire wear. On vehicles with tapered rear
wheel nuts, make sure tapered end of nut goes into
taper on wheel.

Tire Inspection

• Improper tire inflation
maneuverability.
• When replacing a tire always use original
equipment size and type.
• The use of non-standard size or type tires may
affect vehicle handling.
Operating with worn tires will increase the possibility of
the vehicle skidding easily with possible loss of control.
Always replace tires when the tread depth measures 1/
Tire Tread Depth
Replace tires when tread depth is worn to 1/8" (3 mm) or
less.

Tire Pressure

Remove the valve stem cap and check tire pressure
using the tire pressure gauge included in the vehicle's
tool kit.
may affect vehicle
Refer to the warning tire pressure decal applied to the
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
MAINTENANCE
WARNING
Worn tires can cause an accident.
8", (3 mm) or less.
CAUTION
Maintain proper tire pressure.
vehicle.
RZR / RZR S
Tire Pressure Inspection (Cold)
Front
8 psi (55 kPa) 8 psi (55 kPa)
RZR 4
Tire Pressure Inspection (Cold)
Front
10 psi (69 kPa) 12 psi (83 kPa)
2
Rear
Rear
2.27