❸ Part Names Of The Projector - Canon LV 7365 User Manual

❸ Part Names of the Projector
Front/Top
focus ring
(see page 28)
remote sensor
(see page 10)
adjustable tilt foot lock Button
(see page 27)
adjustable tilt foot
(see page 27)
* This security slot supports the MicroSaver ® Security System. MicroSaver ® is a registered trademark of
Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.
Rear
terminal Panel
(see page 7)
remote sensor
(lV-7365/lV-7265)
(see page 10)
Zoom lever
(see page 28)
lens
S -V
ID E
O
IN
V ID
E O
IN
L
SE R
R V IC
A U E PO
D IO R T
IN
D IG A U
A N IT A D IO
A L L IN IN
O G
/
IN -2
A N
A L
O G
A U IN -1
D IO
O U
T
Main Power switch
When you plug the supplied power cord into an active wall outlet
and turn on the Main Power, the POWer indicator turns orange
and the projector is in standby mode.
(see page 24)
Controls
(see page 6)
Ventilation (inlet) / filter Cover
(see page 56)
two filters on lV-7365/lV-7265/lV-7260
One filter on lV-X7
Built-in security slot (
Ventilation (inlet)
lens Cap
Monaural speaker
(lV-7365/lV-7265: 5W)
(lV-7260/lV-X7: 1W)
Ventilation (outlet)
heated air is exhausted from here.
aC input
Connect the supplied power cord's two-pin plug here, and
plug the other end into an active wall outlet. (see page 23)

. Introduction
do not block this vent.
troubles or fire can result.
)*
Be sure to remove the lens cap during
projection. the cap can deform or fire
can occur.
do not block this vent. troubles or
fire can result.