Sanding Operation; Maintenance - Makita M9204 Instruction Manual

OPERATION

Sanding operation

CAUTION:
Never switch on the tool when it
is in contact with the workpiece, it may cause an
injury to operator.
NOTICE:
Never run the tool without the abrasive
disc. You may seriously damage the pad.
NOTICE:
Never force the tool. Excessive pressure
may decrease the sanding efficiency, damage the
abrasive disc or shorten tool life.
NOTICE:
Using the tool with the pad edge con-
tacting the workpiece may damage the pad.
► Fig.5
Hold the tool firmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
workpiece surface. Keep the pad flush with the work-
piece and apply slight pressure on the tool.
NOTE: The sanding pad rotates clockwise during
the loaded operation, but it may rotate counter-
clockwise during the no-load operation.

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
6 ENGLISH