(Moving) Performing white horses : Assembly Instructions
View of completed model
Assembly Instructions : Twelve A4 sheets (No. 1 to No. 12)
* Build the model by carefully reading the Assembly Instructions , in the parts sheet page order.
*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.
Assembly Instructions
Mountain fold(dotted line)
Make a mountain fold.
Valley fold(dashed and dotted line)
Make a valley fold.
Scissors line(solid line)
Cut along the line.
Cut in line(solid line)
Cut along the line.
Scissors, set square, glue(We recommend stick glue), pencil, used
Tools and materials
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
Assembly tip
fold lines and make sure rounded sections are nice and stiff.
Glue, scissors and other tools may be dangerous to young children
Caution
so be sure to keep them out of the reach of young children.
* Turn the handle to make
the horses prance in time
with the trainer's baton.
Glue
The glue spot(colored dot)
shows where to apply the glue.
Glue spot(Red dot)
Glue parts with the same number together.
Glue spot(Green dot)
Glue within the same part.
Glue spot(Blue dot)
Glue to the rear of the other part.
©
Canon Inc.
Before starting assembly : Writing the number of each section on
its back side before cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even after
cutting out the sections.)
Round bar : Use to give parts a curved surface.
Tweezers : Useful in working with fine parts.
Caution :
Performing horses' tricks require two pieces of thread, approximately 20cm long. Use silk or other durable thread.
Caution :
Spread glue in
a thin even layer,
then glue parts 7
and 8 to the base.
©
Hideharu Naitoh & G&P
Indicates where sections should be glued together.
Indicates where to insert sections.
Do not glue the sections together.
Indicates the order for assembling parts.
Cut along the line.
Be sure to build
this model carefully.
Glue parts 7, 8, and 10 to
the reverseside of part 1.