Lenovo ServeRAID M1210 Quick Installation Manual

Quick Installation Guide
ServeRAID M1210 SAS/SATA Controller for Lenovo System x
DANGER
Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
• Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this
product during an electrical storm.
• Connect all power cords to a properly wired and grounded electrical outlet.
• Connect to properly wired outlets any equipment that will be attached to this product.
• When possible, use one hand only to connect or disconnect signal cables.
• Never turn on any equipment when there is evidence of fire, water, or structural damage.
• Disconnect the attached power cords, telecommunications systems, networks, and modems before you
open the device covers, unless instructed otherwise in the installation and configuration procedures.
• Connect and disconnect cables as described in the following table when installing, moving, or opening
covers on this product or attached devices.
To Connect:
1. Turn everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON.
Thank you for purchasing the ServeRAID M1210 SAS/SATA Controller
(hereafter referred to as controller) for Lenovo
install the controller, take a few minutes to read this quick installation
guide.
For more information about the controller, refer to the
ServeRAID M1210 SAS/SATA Controller for Lenovo System
x User's Guide on the ServeRAID matrix Web site at
https://support.lenovo.com/us/en/documents/serv-raid.
Technical support: To get assistance for installing, configuring, or
using the controller, go to http://www.lenovo.com/support.
To Disconnect:
1. Turn everything OFF.
2. First, remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.
®
System x. Before you
1