Usb Port - Tripp Lite NGI-M08POE8-L2 Owner's Manual

POST
PoE
(1~8)
1000
LNK/ACT

3.4. USB port

A USB device can be inserted for auto firmware upgrades. Switch auto-checks the firmware
version present in the USB device and upgrades if newer version of Firmware is present.
For example, if you are running with Firmware version 1.0.0.S0 you need to upgrade the
firmware to version 1.0.1.S0 then you need to follow these steps:
1. Create a folder with model name in USB (eg: NGI-M08POE8-L2)
Note: don't add 'A' in folder name.
2. Insert new firmware file in that folder.
Note: There should be only one firmware in that folder. If there are more than one firmware, the
upgrade process will stop.
3. Insert the USB drive into the NGI-M08POE8-L2's USB port.
4. Switch updates itself to new firmware version, else it will be ignored for following
conditions.
- If there are more than one Firmware files.
- If the Firmware version is identical to the image on the device.
5. After Upgrade Complete or Upgrade Ignored, the Switch will download the latest
running configuration & syslog files into the USB drive by creating a folder with a
name that is the same as the switch's MAC address.
Configuration File Name Format: config_ YYYYMMDDhhmmss.cfg
SYSLOG File Name Format: flash_ YYYYMMDDhhmmss.log
Off No alarm to report.
Illuminated Switch is ready or running.
Blinking Switch is not ready.
Illuminated Power feeding on particular PoE port.
Off No power is feeding.
Illuminated Port is operating in 1000Mbps speed.
Off Port is operating in 10/100Mbps speed.
Illuminated Ethernet link up.
Blinking Activity (receiving or transmitting data).
Off Port disconnected or link failed.
25