Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for AEG KO_FAVORIT 4270 I
Summary of Contents for AEG KO_FAVORIT 4270 I
- Page 1 ÖKO_FAVORIT 4270 i Dishwasher User Instructions...
- Page 2 Dear customer, Please read these user instructions carefully. Above all please observe the safety instructions on the first few pages ofthese user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance.
-
Page 3: Table Of Contents
CONTENTS Operating instructions Safety instructions ..........Disposal . - Page 4 Contents Installation and Connection Instructions Installing the Dishwasher ........31 Dishwashers That Can Be Integrated .
-
Page 5: Operating Instructions
OPERATING INSTRUCTIONS Safety instructions The safety features of AEG electrical appliances comply with accepted technical standards and the German Appliance Safety Law. Neverthe- less, as a manufacturer we consider it our obligation to make you aware of the following safety information: Installation, connection and initial use •... -
Page 6: General Safety
• If the mains cable for the appliance is damaged, it must be replaced with special cable (obtainable from AEG customer service) by an AEG authorised customer service centre. • Never unplug the appliance by pulling on the cable, always pull on the plug. -
Page 7: Disposal
• Do not sit or stand on the open door, the appliance may tip over. • In the event of a fault, shut off the water supply at the tap, then switch off the appliance and unplug. In the case of a permanent con- nection: pull or unscrew the fuse(s). -
Page 8: Appliance Features And Control Panel
Operating instructions Appliance Features and Control Panel Top Spray Nozzle Rubber Seal for Connecting the Water Feed to the Upper Spray Spray Arms Container for Special Salt Container for Rinse Aid Detergent Dispenser Rating Filters plate... -
Page 9: Control Panel
Control panel Function Softener Button Button Control Field The Control Field comprises the ON/OFF switch and the programme buttons with LED indicators. Softener and Function Button: in addition to the wash programme marked, it is also possible to adjust the dishwasher's water softener using the combination of these buttons. -
Page 10: Adjust The Water Softener
Operating instructions Adjust the water softener To avoid the scale deposits on the dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content, water. The dish- washer therefore has a built-in water softener, in which tap water from a hardness of 4 °d (German degree) is softened with the aid of special salt. -
Page 11: Filling With Special Salt For The Water Softener
5. Pressing the water softener button (Exception: hardness setting 0 follows hardness setting 9). 6. When the hardness setting is correct, press the ON/OFF switch. The hardness setting is then saved. Filling with Special Salt for the Water Softener Use only special salt for dishwashers. Never fill the salt container with any another type of salt (e.g. -
Page 12: Filling With Rinse Aid
Operating instructions Depending on the size of the salt grains, it can take several hours for the salt to dissolve in the water and for the SALT indicator to extin- guish. The setting of the water softener and thus the consumption of salt are dependent on the hardness of the local water. -
Page 13: Adjusting Rinse Aid Dosing
4. Fill with rinse aid exactly up to the level marked “max”; this corresponds to a quantity of approx. 140 ml. 5. Close the lid and press until it locks into place. 6. Wipe up any spilt rinse aid with a cloth. -
Page 14: In Daily Use
Operating instructions In Daily Use • Is it necessary to refill with special salt or rinse aid? • Load cutlery and dishes into the dishwasher • Fill with dishwasher detergent • Select a wash programme suitable for the cutlery and dishes •... -
Page 15: Loading Cutlery
– To avoid damage to glasses, they must not touch – Do not lay small objects (e.g. lids) in the cutlery rack Loading Cutlery Long, pointed items of cutlery in the cutlery rack are a hazard, particularly to children (see Safety Instructions). To ensure that all items of cutlery are completely washed, you should 1. -
Page 16: Loading Pans, Frying Pans And Large Plates
Operating instructions Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower rack. Your dishwasher has one of the following four types of lower rack: Type 1: None of the plate inserts in the lower rack can be removed Type 2: The right-hand plate inserts in the lower rack can be folded over to the left To ease the loading of large items,... - Page 17 Type 3: The right-hand plate inserts in the lower rack can be folded across one another To ease the loading of large items, the two right-hand plate inserts in the lower rack can be folded across one another. Type 4: The two rear plate inserts in the lower rack can be folded across one another To ease the loading of large items, the two rear plate inserts in the lower...
-
Page 18: Loading Cups, Glasses And Coffee Services
Operating instructions Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items. -
Page 19: Filling With Detergent
Filling with Detergent Only use dishwasher detergent. Fill with detergent: – Prior to the start of a wash programme (not for the pre wash pro- gramme). The detergent is released into the wash water during the programme. Please observe the manufacturer's dosing and storage recommenda- tions as stated on the detergent packaging. -
Page 20: Use Of "3 In 1"/ Combi Detergent Tablets
Operating instructions Use of "3 in 1"/ Combi Detergent Tablets General Advice These products are tablets with combined detergent/rinse-aid and salt functions. 1. Before using these products you should first check that the water hard- ness in your supply is compatible with the use of these products as per the detergent manufacturers instructions (on the product packaging). -
Page 21: Bio Wash Programmes And Concentrated Detergents
Bio Wash Programmes and Concentrated Detergents Based on their chemical composition, dishwasher detergents can be split into two basic types: – Conventional, alkaline detergents with caustic components – Weak alkaline concentrated detergents with natural enzymes. The use of BIO wash programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes;... -
Page 22: Selecting The Wash Programme (Programme Table)
Operating instructions Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: Type of Dishes In Addition Type of Soiling Suitable Wash Programme: Programme Sequence Consumption Figures: Duration Energy Water During BIO programmes the water is briefly heated to more than 50 °C so that the active oxygen becomes effective. -
Page 23: Start The Wash Programme
Start the wash programme 1. Check that the dishes and cutlery are loaded into the dishwasher in such a manner that the spray arms are free to rotate. 2. Open the tap fully. 3. Shut the door. 4. Press the ON/OFF button. The ON/OFF button indicator illuminates. 5. -
Page 24: Load Sensing - Sensor Logic
Operating instructions Interrupting the wash programme by opening the door of the dishwasher Hot steam may escape from the appliance when opening the door. There is a risk of scolding! Open the door carefully. 1. Open the door of the dishwasher. The wash programme stops. 2. -
Page 25: Switching Off The Dishwasher
Switching Off the Dishwasher Only switch off the dishwasher when END is illuminated on the pro- gramme progress display. 1. Press the ON/OFF button. The ON/OFF button indicator extinguishes. Hot steam may escape from the appliance when opening the door immediately after the end of the programme. -
Page 26: Cleaning The Filter
Operating instructions Cleaning the Filter The filters in the base of the washing compartment are to a large extent self-cleaning. Nevertheless the filters should be checked and cleaned from time to time. Dirty filters will degrade the washing result. 1. Open the door, remove the lower rack. -
Page 27: What To Do, When
What to do, when ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call in customer service to resolve one of the malfunctions listed here, or rectify an error made in the operation of the appliance, the customer service engineer’s visit is not free of charge, even during the period of guarantee. -
Page 28: Problems Occur During Use Of The Dishwasher
Operating instructions ...problems occur during use of the dishwasher. Malfunction The programme does not start. Rust spots are visible in the washing compart- ment. There is a whistling noise during washing..the wash results are not satisfactory. The dishes are still dirty. –... -
Page 29: Technical Data
There are streaks, milky spots or a bluish coating on glasses and dishes. – Lower rinse aid dosing. There are dried water drops on the glasses and dishes. – Increase rinse aid dosing. – The detergent may be the cause. Contact the detergent manufac- turer’s customer advisor. -
Page 30: Notes For Test Institutes
Operating instructions Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table). Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see Programme Table). -
Page 31: Installation And Connection Instructions
INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted to ensure that it is stable and level. • To compensate for unevenness in the floor and to match the height of the appliance to that of surrounding units extend the threaded feet by unscrew- ing:... -
Page 32: Dishwashers That Can Be Integrated
Installation and Connection Instructions • Depending on type, the dishwasher is to be installed as follows: Dishwashers That Can Be Integrated (see installation template supplied) The door of the appliance can be fitted with a wooden furniture door with the following dimensions: Width 587mm 591 –... - Page 33 If the dishwasher is installed underneath a kitchen work surface, the original work surface of the dishwasher is to be removed as follows: 1. Unscrew the screws from the posi- tioning plates on the back (1). 2. Slide the appliance's work surface approx.
-
Page 34: Connecting The Dishwasher
Installation and Connection Instructions Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations. • The dishwasher can be connected to cold and hot water supplies up to max. -
Page 35: Water Inlet Hose With Safety Valve
The following section is only applicable to dishwashers that have a safety valve on the threaded hose fitting for the tap: Water inlet hose with safety valve After connecting the double-walled water inlet hose, the safety valve is next to the tap. Therefore the water inlet hose is only under pressure while the water is running. -
Page 36: Water Drain
In the case that you wish to hang the drain hose in a wash basin, use a detachable hose elbow. You can obtain this from AEG customer service under spare part number ET 646 069 190. 1. Fit the elbow to the drain hose. -
Page 37: Leak Prevention System
Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the safety valve immediately interrupts the sup- ply of water to the appliance and the drain pump switches on. By this means water can neither escape nor overflow. -
Page 38: Connections
Installation and Connection Instructions Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation;... -
Page 39: Service Departments
1 Chausee Street Tel.: 905 829 3980 Port Louis Fax: 905 829 3985 Tel.: 25355 Korea (South) Namibia Core Incorp. AEG NAMIBIA (PTY) LIM- 3/F Chewoo Bldg. ITED-Jeppe Street 200 Nonhyun-Dong Northern Industrial Area Kangnam-Ku Windhoek Seoul Tel.: (061) 21-6082/4... - Page 40 Tel.: 61 1234 137 Fax: 7351124 Fax: 61 1234 238 Slovakia Rep. South Africa Electrolux Slovakia S.R.O. AEG (Pty) Ltd. Seberiniho 1 55, 12th Road 821 03 Bratislava P.O. Box 1 02 64 Tel.: 02 4333 4322, 4355 Kew/Johannesburg 2000 Fax: 02 4333 6976 Tel.: 8069111...
-
Page 41: Guarantee Conditions
In diesen Ländern gelten die Garantiebedingungen der örtlichen Part- ner. Diese können dort eingesehen werden. Further after-sales service agencies overseas In these countries our AEG agents’ own guarantee conditions are appli- cable. Please obtain further details direct. Autres agences étrangères assurant le service après-vente Dans ces pays, les conditions de garantie des concessionnaires de la région sont valables. -
Page 43: Service
Service SERVICE In the section "What to do, if..." the most important sources of faults that you can rectify yourself are summarised. If, nevertheless, you call in customer service to resolve a problem listed in these instruction, or because of an error made in operating the appliance, the customer service engineer’s visit is not free of charge, even during the warranty period. - Page 44 USD 14 billion in more than 150 countries around the world. AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 822 945 986 -00- 0103 Subject to change without notice...