Advertisement
Presettings on DT-930
Take your DT-930 and switch it on by pressing the buttons [S], [.], and [PW] simultaneously.
You are in the operating system mode (SYSTEM MENU) now. You can select a menu item
by pressing its number on the keypad of the mobile terminal. To go one level back press
[CLR].
Starting from SYSTEM MENU, choose 3:DATE/TIME, and enter both date and time
correctly. With the [CLR] button you can return to the SYSTEM MENU. Choose
4:TRANSMIT, and then 4:UTILITY. Check whether "NORM" is shown beside 4:FILE
MODE. If not, press key [4] to select 4:FILE MODE to reach the file mode menu. Push key
[1] to select 1:NORMAL MODE, and confirm with the [ENT] key. Wait until the drive is
newly formatted. Push [CLR] until you reach the TRANSMIT menu again. Check whether
the following entry is shown next to 5: PROTOCOL: "MLT". If " FLINK " is displayed
instead, press button [5]. You reach the PROTOCOL menu. Push button [2] and confirm
again with the [ENT] button.
Check whether "SIR" is shown under 6:PORT. If not, press button [6]. You enter the COM
PORT menu. Push button [1] and the [ENT] button subsequently. Check whether "115K" is
displayed beneath 7:SPEED. If a different setting is announced, press button [7]. You reach
the COM SPEED menu. Push button [6] to select 6:115.2, and then the [ENT] button.
Advertisement
