Sony VPL-CX75 Operating Instructions Manual page 18

Projector setting
Click [Projector Setting].
Projector Name: enter a projector name.
Simple Mode: set [On] or [Off].
When [Off] is selected, set the
following.
Network Mode: select [Ad-hoc (peer-to-
peer)] or [Wireless Access Point].
SSID: enter the same network name as that
of the connected computer. A maximum
of 32 characters/numbers can be entered.
Network Channel: when [Ad-hoc (peer-
to-peer)] is selected in [Setting], you can
select from 1 to 11.
When [Wireless Access Point] is
selected in [Setting], [Auto] is selected.
Notes
• When the network channel is changed,
disconnect the projector and computer and
remove the USB wireless LAN module from
the computer. The setting becomes effective
after connecting them again.
• You may not be able to use some channel
according to the country.
Data Encryption (WEP): select the data
encryption system.
You can select from among [Off], [64
18
Setting/Operating via Web
(40) bit ASCII], [128 (104) bit ASCII],
[64 (40) bit HEX], [128 (104) bit HEX].
When [Off] is selected, [Key] does not
function.
Key: when [Data Encryption (WEP)] is
used, enter the key. Enter the same key
as that of the computer.
The number of the characters/figures is
due to the setting of the [Data
Encryption (WEP)].
• 64 (40) bit ASCII: five characters/numbers/
symbols
• 128 (104) bit ASCII: 13 characters/numbers/
symbols
• 64 (40) bit HEX: ten numbers from 0 to 9/
characters from a to f
• 128 (104) bit HEX: 26 numbers from 0 to 9/
characters from a to f
Note
When [64 (40) bit ASCII] or [128 (104) bit
ASCII] is selected, the capital and small letters
are discriminated.
IP Address setting: set [Obtain an IP
address automatically (DHCP)] or
[Specify an IP address].
When [Specify an IP address] is
selected, set [IP Address], [Subnet
Mask] and [Default Gateway].
Note
A DHCP server is needed to make DHCP
valid.
User Memory: select from [User 1] to
[User 5].
Edit: click when you want to enter a new
user memory name.
User Memory Name: enter the user
memory name.
Set to List: click to register the added user
memory name.
Cancel: click to cancel the user memory
name.