Draytek V2862AC-K Quick Start Manual page 13

DSL / DSL 1/2
WCF
USB
2.4G/5G/WLAN
VPN
DMZ
LED on Connector
Left
LAN
LED
P1~P4
Right
LED
Left
P5/
LED
WAN2
Right
LED
The port "P5 / WAN2" is switchable. It can be used for LAN connection or WAN
connection according to the settings configured in WUI.
On The router is ready to access Internet through
DSL link.
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is training.
On The Web Content Filter is active. (It is
enabled from Firewall >> General Setup).
Off WCF is disabled.
On USB device is connected and ready for use.
Off No USB device is connected.
Blinking The data is transmitting.
2.4G/5G: Wireless access point with
On
bandwidth of 2.4GHz/5GHz is ready.
WLAN: Wireless access point is ready.
Off Wireless function is disabled.
It will blink slowly while wireless traffic goes
Blinking
through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will
return to normal condition after two minutes.
(You need to setup WPS within 2 minutes.)
On The VPN tunnel is active.
Off VPN services are disabled
Blinking Traffic is passing through VPN tunnel.
On The DMZ function is enabled.
Off The DMZ function is disabled.
Blinking The data is transmitting.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps
6