Sony HMZ-T1 Reference Manual page 26

Audio
Symptom
There is no sound /
There is static /
Volume cannot be
increased
There is no surround-
sound effect
GB
26
Cause/Action
p Adjust the volume using the VOL +/– buttons.
p Refer to the "Startup Guide" and confirm that the mains lead,
HDMI cable, and connecting cord of the head mounted unit are
connected correctly.
p Confirm that the source signal is supported by the system. For
information on supported signals, see "Supported HDMI input
and output signals:" in "Specifications" (page 29). If the input
signal is unsupported, check the audio output settings of
connected equipment.
p When the PlayStation
the video and audio output settings on the PS3™ do not match
those of this system or the cable and TV in use, there may be no
video and audio outputs. If such symptoms occur, turn off the
PS3™, and then turn it on again by pressing its power button for
at least 5 seconds until you hear a beep sound twice. The video
and audio output settings will automatically be reset to the
standard settings.
p If equipment is connected to the processor unit via an AV
amplifier (receiver), try connecting the equipment directly to the
processor unit instead. For details, refer to the instruction manual
of the equipment used.
p When the system is connected to HDMI CEC-compatible home
theatre systems or AV amplifiers (receivers), check the following
settings.
– Make sure the "Control for HDMI" setting in "General Setup"
is set to "On" (page 21).
– Make sure "Control for HDMI" is activated on the AV
amplifier (receiver) or other equipment. For details, refer to the
instruction manual of the equipment used.
p Make sure the "Surround" setting in "Sound" is not set to "Off"
(page 20).
p Sound perception varies by listener.
®
3 (PS3™) is used with this system and if