How To Set Up Your Easykey; Modify Master Pin Code; User Settings - Philips EasyKey 7100DS User Manual

4 How to set up your EasyKey

Pre-setup Instructions:
◆There are 2 modes in the EasyKey: General mode and Dual-verification mode.
General Mode
Unlock with any registered
identity information
UserCode
◆You can delete a single user information by its user code without having to
delete all user info.
◆You could fill in below blank sheet with user info, in case you need to manage
and check with it.
Code
Name
00
01
02
03
04
05
06
07
08
09
◆Icon annotation
Master One-time Visitor User
Pin Password Pass Password
Code word
Attention
1.Press [*] key to return to the previous menu.
2. The default master PIN code is 12345678.
10
Dual-verification Mode
Unlock with any two methods from
PIN code, card and fingerprint
Fingerprint Password Key Tag
*
User Finger # Key Tag
Code print Input
00-09 Input
◆How to enter master mode
1
Light up
Keypad
2
Press [#] before inputting any other
numbers， then enter master PIN code,
and confirm with [#]. Then you are
entering into the master mode.

Modify master Pin code

Press [#] and input master Pin code,
then press [#] to confirm.
1
Press [1] and choose to modify master
Pin code.
Enter the new master PIN code and
press [#] to confirm. Re-enter the new
Master PIN code and press [#]. After
hearing a voice prompt of "Succeeded",
press [*] until you exit master mode.

User Settings

Add User Password
Press [#] and input master Pin code,
then press [#] to confirm.
2 1
Press[2] to add new users, then press[1]
to add user code(s),he system will auto
number and proceed with voice prompt.
Enter a user PIN code of 6 to 12 digits
and press [#] to confirm. Then re-enter
it and press [#] to confirm. After hearing
a voice prompt of "Succeeded", press
[*] until you exit master mode.
Add one-time password
Press [#] and input master Pin code,
then press [#] to confirm.
2 2
Press[2] to enter user settings, then
press[2] to add one-time user password.
Enter a user PIN code of 6 to 12 digits
and press [#] to confirm. Then re-enter
it and press [#] to confirm. After hearing
a voice prompt of "Succeeded", press
[*] until you exit setting mode.
11