Infrared Data Transfer Is Not Working - Fujitsu Point 1600 User Manual

Infrared Data Transfer Is Not Working

If you are experiencing problems transferring data over the pen tablet's infrared
interface (IrDA port), check the following:
• Can the IrDA port on the pen tablet "see" the IrDA port on the other device? There
must be a direct line-of-sight path between the IrDA port on the Point 1600 pen
tablet and the IrDA port on the other device.
• Ensure that you are pointing the IrDA port on the pen tablet at the port on the
other device. The "viewing angle" from the IrDA port on the pen tablet must not
be more than 15 degrees from center.
• Ensure that the pen tablet is close enough to the other device. The distance
between the two devices must be no more than approximately 3 feet (1 meter).
• The device that you are trying to communicate with must be compliant with the
IrDA Standard Revision 1.1 or lower. If you are unsure, contact your local help
desk.
• Your system must be properly configured before the IrDA port can be used.
Contact your local help desk for assistance if necessary.
Troubleshooting
3
3-7